GRANIT

Field of application: plastering of plastered, concrete, silicate blocks, plasterboard, brickwork and other mineral surfaces inside and outside buildings.  Plaster is not suitable for covering horizontal surfaces, as well as surfaces subject to water loads.

Properties: good adhesion to the surface, weak, specific smell, plastic, easy to apply and smooth, resistant to the effects of atmospheric factors. Thanks to the biocidal product (the active ingredient of which is 4,5-dichloro-2-octyl-2H-isothiazol-3-one, 3-iodo-2-propynylbutylcarbamate, 2-octyl-2H-isothiazol-3-one) granite mosaic GRANIT plaster is resistant to mold (fungi), algae and bacteria. The composition of the plaster uses natural granite pebbles, so use plaster from one batch for plastering, as there may be slight color differences.

Surface preparation: The substrate must be firm (not crumbly), dry, clean and smooth. Remove adhesion-reducing substances - grease, grease, dust, mortar residues, old peeling paint, chalky surfaces. Weak and porous surfaces should first be primed with PRO primer SILSIL, then with PRO primer KONTAKT, which increases adhesion to the surface, immediately prime strong surfaces with PRO primer KONTAKT, which increases adhesion to the surface (it is recommended to tint the primer in the color corresponding to the mosaic plaster).

Working conditions: the substrate and ambient temperature during work and drying must not be lower than +5°C and not higher than +30°C, the optimal working conditions are at a temperature of +20°C and 65% relative air humidity. Do not work in direct sunlight, strong drafts, or rain. During drying, the mosaic plaster must be protected from direct sunlight. Cement surfaces must be mature (apply GRANIT mosaic plaster on new plaster or reinforcement mixture layer no earlier than 28 days, and on concrete - no earlier than 90 days). Make sure that aggressive chemical substances do not migrate to the surface applied with GRANIT mosaic plaster.

Plastering: Mix the mosaic plaster well before use. Apply evenly and smooth by hand using a stainless steel trowel - putty.

Consumption: GM (2mm): ~4.1 - 4.8 kg/m²; GS (1.2mm) ~2.3 – 3.0 kg/m²

Drying time: at a temperature of +20°C and a relative air humidity of 65%: ~48 hours.

Cleaning tools: Rinse with water immediately after work.

Storage and transport conditions: at a temperature not lower than +5°C and not higher than +30°C in a tightly closed container. Protect from direct sunlight and freezing!

Environmental and occupational safety: Do not pour plaster into drains, watercourses or soil. Try not to inhale the vapors. Avoid contact with eyes, skin or clothing. If swallowed, call a poison control and information office or seek medical attention immediately. In case of contact with eyes, wash immediately with plenty of water. Keep out of reach of children. EUH208 - May cause an allergic reaction. Contains 3(2H)-isothiazolone, 5-chloro-2-methyl- mixture with 2-methyl-3(2H)-isothiazolone, 1,2-benzisothiazol-3(2H)-one, 2-methyl-2H-isothiazolone - 3-one, 2-octyl-2H-isothiazol-3-one and 2,2-dibromo-3-nitrilepropionamide.